• 2026 bundle: free window or gutter cleaning
Dark oil stain on a concrete driveway next to a cleaned section

How to Remove Oil Stains From a Concrete Driveway: What Works and What Does Not

Quick answer: blot fresh oil immediately and cover it with an absorbent like cat litter or sawdust, then scrub with a degreaser and rinse. Old oil stains are harder, because the oil has soaked into the pores of the concrete. They usually need a stronger degreaser and a longer dwell time, or professional-grade degreasing. Pressure washing alone rarely lifts them.

A dark oil spot in the middle of the driveway is one of the most common complaints homeowners have. Concrete looks solid, but it is porous, and oil soaks in like a sponge. Here is what works.

Why oil is hard to remove

Concrete is full of tiny pores. When oil lands, it wicks into them and spreads. The longer it sits, the deeper it goes. Heat from the sun can pull oil toward the surface and back out, which is why some stains seem to return after cleaning.

Fresh stains: act fast

  1. Blot, do not wipe. Soak up the oil with paper towels or rags.
  2. Cover with an absorbent. Cat litter, sawdust or a commercial oil absorbent works. Pile it on and press it in.
  3. Wait several hours or overnight. Let it draw the oil up.
  4. Sweep it away. Dispose of the oily absorbent correctly. Do not wash it down a storm drain.
  5. Scrub with a degreaser. Use a concrete degreaser and a stiff brush.
  6. Rinse with a hose or low-pressure water.

Old stains: what to try

Concrete degreaser

Apply a quality degreaser made for concrete, work it in with a stiff brush, let it dwell for the time on the label, scrub again and rinse. Repeat if needed.

Poultice

A poultice is a paste made from an absorbent powder and a solvent that draws oil out of the pores as it dries. It can work on deep stains but takes time and patience.

Professional degreasing and surface cleaning

Professionals use stronger degreasers with a longer dwell time, followed by a surface cleaner. The cleaner has time to draw oil out of the pores so the rinse can carry it away. It is the most effective method for large stains, though deep, old stains may leave a faint shadow.

What usually does not work

  • Pressure washing alone. Water pushes oil around and can spread the stain.
  • Soda, dish soap or bleach. Mild cleaners may lighten a fresh spot, but they rarely handle deep oil. Bleach can also cause other problems.
  • Wire brushes. They can scratch the surface and leave marks.
  • Paint or sealer over the top. Oil can bleed through coatings and cause peeling.

Be careful with chemicals

Always follow product directions, wear gloves and eye protection, keep products away from drains, lawns and plants, and avoid mixing chemicals. Rinse water should not flow into storm drains. If in doubt, call a pro.

Will the stain disappear completely?

Not always. Fresh stains often come out entirely. Old, deep stains may fade to a light shadow. If the stain sat for years, set expectations that the result may be an improvement rather than perfect.

Preventing future stains

  • Fix leaks on vehicles
  • Use a drip pan or mat under parked cars
  • Clean spills right away
  • Seal the driveway to slow absorption, see sealing prep

When to call a professional

Call in a pro for large areas, long-standing stains or if you want a uniform finish. Even cleaning across the slab avoids the patchy look you can get from spot treating. Our concrete cleaning starts at $0.23 per square foot, and deep oil stains are quoted after we see the surface. We also clean commercial lots and loading areas, see commercial concrete cleaning.

Frequently Asked Questions

Does WD-40 remove oil stains from concrete?

No. It is another oil product and can make the stain worse. Use an absorbent and a concrete degreaser instead.

Can you remove old oil stains from a driveway?

Often you can lighten them a lot, and sometimes remove them, with a strong degreaser, repeated treatment or professional degreasing.

Is baking soda good for oil stains?

It can help absorb a light, fresh spill but is not strong enough for deep stains.

Should I pressure wash oil stains?

Not by itself. Pre-treat with a degreaser first, then rinse.

How much does it cost to clean oil stains?

Standard driveway cleaning starts at $0.23 per square foot, and heavy oil stains are quoted after we inspect the surface.

Get a Free Quote from ALWAYS B.I.G.

Ready to put this to work? Use the instant estimate on our site, book online in a few clicks, or call or text (216) 202-8264. We serve homeowners and businesses across Cleveland and Northeast Ohio.


About the Author

Michael Betts is the founder of ALWAYS B.I.G. Power Washing Pros, an owner-operated exterior cleaning company serving homeowners and businesses across Cleveland and Northeast Ohio with house washing, roof cleaning, gutter services, window cleaning and concrete cleaning.

Call or text (216) 202-8264, email michael@ohiopowerwashingpros.com, or read more homeowner guides in the Curb Appeal Report.

Call Book NowQuote